Basic Operation Guide 2014/02
The parameters are explained in the following table.
DescriptionParameter
The EEE configuration status, read from the
configuration database.
EEE Config
EEE mode is enabled.
• Enabled
EEE mode is disabled.
• Disabled
Current EEE operational status.Current Status
The port is advertised and auto-negotiated EEE
with link partner (an EEE-capable partner.) EEE
mode is enabled.
• Active
Set to one of the following conditions:
• Inactive
• EEE configuration is disabled on the local port.
• Local port advertises EEE capabilities with
"EEE disabled" link partner or non-EEE link
partner.
• Auto-negotiation is mandatory for EEE to work.
EEE configuration will not be applied if the
port is in forced/manual (speed-duplex) mode.
The current status will be ‘inactive" for
forced/manual mode port configuration.
• EEE is not supported for 10Base-T. The current
status will be ‘inactive' if the link is operating
in 10Base-T mode.
The local physical interface does not have EEE
capability.
• Unsupported
Current value of transmit wake-up time (in
microseconds.)
txWake
NOTE: The interface modules do not support adjustment of both transmit and
receive wake-up times. Therefore, txWake is constant.
LLDP support for EEE
Layer 2 (data link layer) EEE capability is a feature that allows fine-tuning for EEE that uses LLDP
TLVs for the negotiation of physical link partners' wake up time values. An EEE-capable port notifies
its link partner about the EEE capabilities supported. The ports then negotiate how to best optimize
energy efficiency.
Syntax
[ no ] lldp config port-list dot3TlvEnable eee_config
Enables the advertisement of Layer 2 EEE TLVs for a given port or range of ports.
The no form of the command disables the advertisement of EEE TLVs.
(Default: Enabled)
Configuring the savepower port-low-pwr option 147