Basic Operation Guide 2014/02

HP Switch(config)# interface c3-c6
HP Switch(eth-C5-C8)#
HP Switch(config)# interface trk1
HP Switch(eth-Trk1)#
Commands executed at configuration level for entering port and trk1 static
trunk-group contexts, and resulting prompts showing port or static trunk contexts.
HP Switch(eth-C5-C8)#
HP Switch(eth-Trk1)#
HP Switch(eth-C5-C8)# ?
HP Switch(eth-C5-C8)# ?
Lists the commands you can use in the port or static trunk context, plus the Manager,
Operator, and context commands you can execute at this level.
Figure 8 Context-specific commands affecting port context
VLAN context. Includes VLAN-specific commands that apply only to the selected VLAN, plus
Manager and Operator commands. The prompt for this mode includes the VLAN ID of the selected
VLAN. For example, if you had already configured a VLAN with an ID of 100 in the switch:
HP Switch(config)# vlan 100
Command executed at configuration level to enter VLAN 100 context.
HP Switch(vlan-100)#
Resulting prompt showing VLAN 100 context.
Using the CLI 33