Basic Operation Guide 2014/02

Example 63 Running config output for a specified interface range
HP Switch(config)# show running-config interface A2-A3
Running configuration:
interface A2
disable
name "test1"
flow-control
broadcast-limit 80
speed-duplex 100-full
unknown-vlans block
qos priority 4
gvrp join-timer 30 leave-timer 60 leaveall-timer 700
dhcp-snooping trust
lacp passive
bandwidth-min output 20 10 10 10 20 10 10 10
rate-limit bcast in percent 75
ipv6 access-group "check" in
untagged vlan 1
exit
interface A3
disable
name "test1"
flow-control
broadcast-limit 80
speed-duplex 100-full
unknown-vlans block
qos priority 4
gvrp join-timer 30 leave-timer 60 leaveall-timer 700
dhcp-snooping trust
lacp passive
bandwidth-min output 20 10 10 10 20 10 10 10
rate-limit bcast in percent 75
ipv6 access-group "check" in
untagged vlan 1
exit
The example below shows an example of the running config file for a range of interfaces after
some configuration changes have been made.
84 Switch Memory and Configuration