Management and Configuration Guide K/KA/KB.15.15

a broadcast storm is detected. Commands can be used only to support broadcast traffic and not
multicast and unicast types of traffic.
The waiting period range for re-enabling ports is 0 to 604800 seconds. The default waiting period
to re-enable a port is zero which prevents the port from automatic re-enabling.
NOTE: Avoid port flapping when choosing the waiting period by considering the time to re-enable
carefully.
Configuration Commands
Use the following commands to configure the broadcast-storm on a port.
Syntax
[no]fault-finder broadcast-storm [ethernet]<port-list> action
[warn | warn-and-disable <seconds>][percent <Percent> |
pps<rate>]
To remove the current configuration of broadcast-storm on a port, use:
Syntax
[no]fault-finder broadcast-storm [ethernet] <PORT-LIST>
Configuration example 1
Syntax
HP Switch(config)# fault-finder broadcast-storm [ethernet]
<A1> action [warn-and-disable <65535>]< percent 10>
Configuration example 2
Syntax
HP Switch(config)# fault-finder broadcast-storm [ethernet]
<A2> action [warn-and-disable]<pps 100>
Configuration example 3
Syntax
HP Switch(config)# fault-finder broadcast-storm
[ethernet]<A22> action [warn]<pps100>
Viewing broadcast-storm configuration
Use the following command to display the broadcast-storm-control configuration.
Syntax
show fault-finder broadcast-storm [<ethernet> port-list]
Show example 1
Disable timer leftDisable timerAction
Rising
thresholdPort statusBcast stormPort
65535warnanddisable10%DownYesA1
Viewing and configuring port trunk groups 133