Management and Configuration Guide K/KA/KB.15.15

Show example 2
HP Switch (config)# show fault-finder broadcast-storm
Disable timer
left
Disable timerActionRising
threshold
Port statusBcast stormPort
910warnanddisable200 ppsDownYesA1
Show example 3
HP Switch (config)# show fault-finder broadcast-storm A1
Disable timer
left
Disable timerActionRising thresholdPort statusBcast stormPort
noneUpNoA1
Show example 4
HP Switch (config)# show fault-finder broadcast-storm
Disable timer
left
Disable timerActionRising thresholdPort statusBcast stormPort
warn75%UpYesA1
Definitions
broadcast-storm Configure broadcast storm control.
pps Rising threshold level in number of broadcast packets per second.
Percent Rising threshold level as a percentage of bandwidth of the port. The
percentage is calculated on 64 byte packet size.
warn Log the event only.
warn-and-disable Log the event and disable the port.
seconds Re-enable the port after waiting for the specified number of seconds.
Default is not to re-enable.
Event logs
Depending on the configuration of broadcast storm control several of the following messages can
be logged:
• FFI: port <ID>-Administrator action required to re-enable.
• FFI: port <ID>-Excessive Broadcasts. Broadcast-storm control threshold <configured value>
percent exceeded.
• FFI: port <ID>-Excessive Broadcasts. Broadcast-storm control threshold <configured value>pps
exceeded.
• FFI: port <ID>-Port disabled by Fault-finder.
• ports: Fault Finder(<FF ID>) has disabled port A1 for 100 Seconds.
The following messages can be logged after the port is enabled:
• ports: port <ID> timer (<FF ID>) has expired.
• ports: port <ID> is now on-line.
134 Port Trunking