KB.15.15

This command operates the same way in any CLI context. If the command lists Disabled for a

port, there are no bandwidth minimums configured for any queue on the port. (See the description

of the no form of the bandwidth-min output command on page 13-24.)

Example

To display the GMB configuration resulting from either of the above commands:

Figure 79 Listing the GMB configuration

(HP_Switch_name#) show bandwidth output a1-a5

Outbound Guaranteed Minimum Bandwidth %

Port Q1 Q2 Q3 Q4 Q5 Q6 Q7 Q8

------ --- ------ --- ------ --- --- --- ------

A1 2 3 30 10 10 10 15 strict

A2 2 3 30 10 10 10 15 strict

A3 2 3 30 10 10 10 15 strict

A4 2 3 30 10 10 10 15 strict

A5 2 3 30 10 10 10 15 strict

This is how the preceding listing of the GMB configuration would appear in the startup-config

file.

Figure 80 GMB settings listed in the show config output

(HP_Switch_name#) show config status

Running configuration is same as the startup configuration

(HP_Switch_name#) show config

Startup configuration:

; J9091A configuration Editor; Created on release #K.15.05.0000x

hostnme “HP Switch”

module 1 type J8697A

snmp-server community “public” Unrestricted

vlan 1

name “DEFAULT_VLAN”

untagged A1-A24

ip address dhcp-bootp

exit

interface A1