KB.15.15

Example

Example 88 Displays information about the management stations configured on VLAN 1 to access

the switch

HP Switch# configure terminal

(HP_Switch_name#) vlan 1

HP Switch(vlan-1)# show snmpv3 user

Status and Counters - SNMPv3 Global Configuration Information

User Name Auth. Protocol Privacy Protocol

----------- -------------- -----------------

initial MD5 CFB AES-128

NetworkAdmin MD5 CBC-DES

Assigning users to groups

Next you must set the group access level for the user by assigning the user to a group. This is done

with the snmpv3 group command, as shown in Figure 86 (page 198).

Figure 86 Assigning users to groups

Syntax

[no] snmpv3 group

Assigns or removes a user to a security group for access rights to the switch. To delete an entry,

all of the following three parameters must be included in the command:

Identifies the group that has the privileges that will be assigned

to the user.

group group_name

Identifies the user to be added to the access group. This must

match the user name added with the snmpv3 user command.

user user_name

Defines which security model to use for the added user. An

SNMPv3 access group should use only the ver3 security model.

sec-model [ ver1 | ver2c | ver3 ]

Mapping SNMPv3 communities

SNMP commuities are supported by the switch to allow management applications that use version

2c or version 1 to access the switch.

198 Configuring for Network Management Applications