Management and Configuration Guide K/KA/KB.15.15

Syntax
[no] snmpv3 notify notify_name tagvalue tag_name
Associates the name of an SNMPv3 notification configuration with a tag name used (internally)
in SNMPv3 commands. To delete a notification-to-tag mapping, enter no snmpv3 notify
notify_name.
Specifies the name of an SNMPv3 notification configuration.notify notify_name
Specifies the name of a tag value used in other SNMPv3 commands,
such as snmpv3 targetaddress params taglist tag_name
in Step 5.
tagvalue tag_name
5. Configure the target address of the SNMPv3 management station to which SNMPv3 informs
and traps are sent by entering the snmpv3 targetaddress command.
Syntax
[no] snmpv3 targetaddress [ ipv4-addr | ipv6-addr ]
name
Configures the IPv4 or IPv6 address, name, and configuration filename of the SNMPv3
management station to which notification messages are sent.
Name of the SNMPv3 station's parameters file.params parms_name
The parameters filename configured with params params_name
must match the params params_name value entered with the
snmpv3 params command in Step 6.
Specifies the SNMPv3 notifications (identified by one or more
tag_name values) to be sent to the IP address of the SNMPv3
management station.
taglist tag_name [ tag_name ]
…
You can enter more than one tag_name value. Each tag_name
value must be already associated with the name of an SNMPv3
notification configuration entered with the snmpv3 notify
command in Step 4.
Use a blank space to separate tag_name values.
You can enter up to 103 characters in tag_name entries following
the taglist keyword.
(Optional) Configures the type of messages sent to a management
station.
[ filter [ none | debug | all |
not-info | critical ] ]
(Default: none.)
(Optional) Specifies the UDP port to use.[ udp-port port ]
(Default: 162.)
(Optional) Specifies a range of UDP ports. (Default: 0.)[ port-mask mask ]
(Optional) Specifies a range of IP addresses as destinations for
notification messages.
[ addr-mask mask ]
(Default: 0.)
(Optional) Number of times a notification is retransmitted if no
response is received. Range: 1-255.
[ retries value ]
(Default: 3.)
(Optional) Time (in millisecond increments) allowed to receive a
response from the target before notification packets are
retransmitted. Range: 0-2147483647.
[ timeout value ]
204 Configuring for Network Management Applications