KB.15.15

Figure 97 Detailed output for running configuration changes history

Figure 98 Example of output for running config changes history with detail

Figure 99 (page 210) displays the current status (enabled/disabled) of the SNMP trap type for

running-configuration changes.

Figure 99 SNMP trap configuration status information

Configuring the source IP address for SNMP notifications

Syntax

[no] snmp-server response-source [ dst-ip-of-request [ ipv4-addr |

ipv6-addr ] | loopback0-7 ]

Specifies the source IP address of the SNMP response PDU. The default SNMP response PDU uses

the IP address of the active interface from which the SNMP response was sent as the source IP

address.

The no form of the command resets the switch to the default behavior (compliant with rfc-1517.)

210 Configuring for Network Management Applications