Management and Configuration Guide K/KA/KB.15.15

Example 90 sFlow Destination is OOBM port
HP_Switch (Config#) sflow 1 destination 192.168.2.3 6000 oobm
Figure 102 Output showing OOBM Support Enabled
Figure 103 Output of the running-config File showing the sFlow Destination is the OOBM Port
Viewing sFlow Configuration and Status
The following sFlow commands allow you to display sFlow configuration and status via the CLI.
Figure 105 (page 219) is an example of sflow agent information.
Syntax
show sflow agent
Displays sFlow agent information. The agent address is normally the IP address of the first VLAN
configured.
The show sflow agent command displays read-only switch agent information. The version
information shows the sFlow version, MIB support, and software versions; the agent address is
typically the IP address of the first VLAN configured on the switch.
Figure 104 Example of viewing sflow agent information
Syntax
show sflow receiver instance destination
Displays information about the management station to which the sFlow sampling-polling data is
sent.
The show sflow instance destination command includes information about the
management-station's destination address, receiver port, and owner, as shown in Figure 105
(page 219).
218 Configuring for Network Management Applications