Management and Configuration Guide K/KA/KB.15.15

Figure 105 Example of viewing sFlow destination information
Note the following details:
• Destination Address remains blank unless it has been configured.
• Datagrams Sent shows the number of datagrams sent by the switch agent to the management
station since the switch agent was last enabled.
• Timeout displays the number of seconds remaining before the switch agent will automatically
disable sFlow (this is set by the management station and decrements with time.)
• Max Datagram Size shows the currently set value (typically a default value, but this can also
be set by the management station.)
Syntax
show sflow <receiver instance> sampling-polling <port-list/range>
Displays status information about sFlow sampling and polling.
The show sflow instance sampling-polling<port-list> command displays information
about sFlow sampling and polling on the switch, as shown in Figure 106 (page 219). You can
specify a list or range of ports for which to view sampling information.
Figure 106 Example of viewing sFlow sampling and polling information
NOTE: The sampling and polling instances (noted in parentheses) coupled to a specific receiver
instance are assigned dynamically, and so the instance numbers may not always match. The key
thing to note is whether sampling or polling is enabled on a port, and the sampling rates or polling
intervals for the receiver instance configured on each port.
Viewing the global LLDP, port admin, and SNMP notification status
In the default configuration, LLDP is enabled and in both transmit and receive mode on all active
ports. The LLDP configuration includes global settings that apply to all active ports on the switch,
and per-port settings that affect only the operation of the specified ports.
The commands in this section affect both LLDP and LLDP-MED operation.
Syntax
show lldp config
Displays the LLDP global configuration, LLDP port status, and SNMP notification status.
Example of viewing the general LLDP configuration
show lldp config produces the following display when the switch is in the default LLDP
configuration:
Viewing the global LLDP, port admin, and SNMP notification status 219