Management and Configuration Guide K/KA/KB.15.15

NOTE: When disabled, this TLV cannot be enabled unless the capability TLV
is already enabled.
This TLV enables the switch port to advertise its current PoE state and to read
the PoE requirements advertised by the LLDP-MED endpoint device connected
to the port.
poe
(Default: Enabled)
NOTE: When disabled, this TLV cannot be enabled unless the capability
TLV is already enabled.
Viewing PoE advertisements
To display the current power data for an LLDP-MED device connected to a port, use the following
command:
show lldp info remote-device <port-list>
To display the current PoE configuration on the switch, use the following commands:
show power <port-list>
Configuring location data for LLDP-MED devices
Syntax
[no] lldp config <port-list> medPortLocation Address-Type
Configures location of emergency call data the switch advertises per port in the location_id
TLV. This TLV is for use by LLDP-MED endpoints employing location-based applications.
NOTE: The switch allows one medPortLocation entry per port (without regard to type.) Configuring
a new medPortLocation entry of any type on a port replaces any previously configured entry on
that port.
civic-addr COUNTRY-STR WHAT CA-TYPE CA-VALUE … [ CA-TYPE
CA-VALUE ]
… [ CA-TYPE CA-VALUE ]
Enables configuration of a physical address on a switch port and allows up to 75 characters of
address information.
A two-character country code, as defined by ISO 3166. Some examples
include FR (France), DE (Germany), and IN (India.) This field is required
COUNTRY-STR
in a civic-addr command. (For a complete list of country codes, visit
www.iso.org.)
A single-digit number specifying the type of device to which the location
data applies:
0: Location of DHCP server
WHAT
1: Location of switch
2: Location of LLDP-MED endpoint (recommended
application)
This field is required in a civic-addr command.
Viewing PoE advertisements 229