KB.15.15

Figure 116 Removing an RMON Alarm

Figure 117 Show Command Output for a Specific Alarm

Figure 118 Display Command Output for a Specific Alarm

Figure 119 Output of the running-config File Displaying the Configured RMON Alarm Parameters

sFlow Configuring multiple instances

In earlier software releases, sFlow was configured on the switch via SNMP using a single sFlow

instance. Beginning with software release K.11.34, sFlow can also be configured via the CLI for

up to three distinct sFlow instances: once enabled, an sFlow receiver/destination can be

independently configured for full flow-sampling and counter-polling. CLI-configured sFlow instances

may be saved to the startup configuration to persist across a switch reboot.

LLDP

To standardize device discovery on all HP switches, LLDP will be implemented while offering limited

read-only support for CDP, as documented in this manual. For the latest information on your switch

sFlow Configuring multiple instances 251