KB.15.15

Using a PC workstation, you then execute the following from the CLI to upload the

file to the switch and implement the ACL commands it contains:

HP Switch(config)# copy tftp command-file 18.38.124.16

vlan10_in.txt pc

The switch displays this message:

Running configuration may change, do you want to continue

[y/n]?

To continue with the upload, press the [Y] key. To abort the upload, press the [N]

key. Note that if the switch detects an illegal (non-ACL) command in the file, it

bypasses the illegal command, displays a notice (as shown in Figure 127 (page 283)),

and continues to implement the remaining ACL commands in the file.

Figure 127 Using the copy command to download and configure an ACL

Uploading an ACL command file using Xmodem

Syntax

copy xmodem command-file [ unix | pc ]

Uses Xmodem to copy and execute an ACL command from a PC or UNIX

workstation. Depending on the ACL commands used, this action does one of the

following in the running-config file:

• Creates a new ACL.

• Replaces an existing ACL.

• Adds to an existing ACL.

USB: Uploading an ACL command file from a USB device

Syntax

copy usb command-file filename.txt [ unix | pc ]

Transferring ACL command files 283