KB.15.15

Example

To use Xmodem to copy the output of show config to a serially connected PC:

Figure 128 Sending command output to a file on an attached PC

NOTE: The command you specify must be enclosed in double quotation marks.

Copying Event Log output to a destination device

Syntax

copy event-log smm [ tftp | usb | xmodem ]

Syntax

copy event-log tftp ip-address filepath_filename [oobm]

Syntax

copy event-log usb filename

Syntax

copy event-log xmodem filename

These commands copy the Event Log content to a remote host, attached USB device,

or to a serially connected PC or UNIX workstation.

When used with the smm option, the entire Event Log, both active management

module events and standby management module events, is copied to the selected

host, USB device, or serially connected PC or UNIX workstation.

For switches that have a separate OOBM port, the oobm parameter specifies that

the transfer is through the OOBM interface. If this parameter is not specified, the

transfer is through the data interface. The oobm parameter is not available on

switches that do not have a separate OOBM port.

Example

To copy the event log to a PC connected to the switch:

Figure 129 Sending event log content to a file on an attached PC

Copying crash data content to a destination device

This command uses TFTP, USB, or Xmodem to copy the Crash Data content to a destination device.

You can copy individual slot information or the management module’s switch information. If you

do not specify either, the command defaults to the management function’s data.

Syntax

copy crash-data [ slot-id | master ]

Copying diagnostic data to a remote host, USB device, PC, or UNIX workstation 285