KB.15.15

tftp ip-address filename [oobm]

Syntax

copy crash-data [ slot-id | mm ]

usb filename

Syntax

copy crash-data [ slot-id | mm ]

xmodem

These commands copy the crash data content to a remote host, attached USB device,

or to a serially connected PC or UNIX workstation.

a - h—Retrieves the crash log or crash data from the processor on the

module in the specified slot

slot-id

Retrieves crash log or crash data from the switch's chassis processor.

When "mm" is specified, crash files from both management modules are

copied.

For switches that have a separate OOBM port, specifies that the transfer

is through the OOBM interface. (Default is transfer through the data

interface.)

oobm

You can copy individual slot information or the management module (mm) switch

information. If you do not specify either, the command defaults to the mm data.

Example

To copy the switch's crash data to a file in a PC:

Figure 130 Copying switch crash data content to a PC

Copying crash data with redundant management

When you use redundant management, the copy crash-data command operates somewhat

differently:

Syntax

copy crash-data [ slot-id | mm ] tftp ip-address filename

[oobm]

286 File transfers