Management and Configuration Guide K/KA/KB.15.15

Copies the crash data of both the active and standby management modules to a
user-specified file. If no parameter is specified, files from all modules (management
and interface) are concatenated.
Retrieves the crash data from the module in the specified slot.slot-id
Retrieves the crash data from both management modules and
concatenates them.
mm
For switches that have a separate OOBM port, specifies that the transfer
is through the OOBM interface. (Default is transfer through the data
interface.)
oobm
Copying crash log data content to a destination device
Syntax
copy crash-log [ slot-id | mm ] tftp ip-address filepath and
filename [oobm]
Syntax
copy crash-log [ slot-id | mm ] usb filename
Syntax
copy crash-log [ slot-id | mm ] xmodem
These commands copy the Crash Log content to a remote host, attached USB device,
or to a serially connected PC or UNIX workstation. You can copy individual slot
information or the management module (mm) switch information.
a - h—Retrieves the crash log from the processor on the module in the
specified slot
slot-id
Retrieves the crash log from the switch's chassis processor. When mm
is specified, crash files from both management modules are copied.
mm
For switches that have a separate OOBM port, specifies that the transfer
is through the OOBM interface. (Default is transfer through the data
interface.)
oobm
If you do not specify either, the command defaults to the mm data.
Example
To copy the crash log for slot C to a file in a PC connected to the switch:
Figure 131 Sending a crash log for slot C to a file on an attached PC
Copying crash logs with redundant management (8200zl series switch)
When you use redundant management, the copy crash-log command operates somewhat
differently.
Copying diagnostic data to a remote host, USB device, PC, or UNIX workstation 287