KB.15.15

Figure 6 Disabling time synchronization by disabling the SNTP mode

Deleting an SNTP server

Syntax

[no] sntp server priority <PRIORITY> <ip-address>

Deletes the specified SNTP server.

NOTE: Deleting an SNTP server when only one server is configured disables SNTP unicast

operation.

Disabling SNTP by deleting a server

Syntax

[no] sntp server priority PRIORITY [<1-3>] <IP-ADDR | IPV6-ADDR> [version]

[key-id <KEY-ID>]

Disabling SNTP by deleting the specified SNTP server. Uses the no version of the command to

disable SNTP.

Disabling the TimeP mode

Disabling time synchronization in DHCP mode by disabling the TimeP mode parameter

The [no] ip timep command changes the TimeP configuration for both DHCP and manual

modes, as shown below, and disables time synchronization. Even though the TimeSync mode is

set to TimeP, time synchronization is disabled because the no ip timep command has disabled

the TimeP mode parameter.

Syntax

no ip timep

Enabling and disabling time synchronization protocols 31