KB.15.15

Example 5 Disabling TimeP in DHCP mode

(HP_Switch_name#) no ip timep

(HP_Switch_name#) show timep

Timep Configuration

Time Sync Mode: Timep

TimeP Mode : Disabled

Example 6 Disabling TimeP in manual mode

Timep Configuration

Time Sync Mode: Sntp

TimeP Mode : Disabled

Poll Interval (min) [720] : 720

(HP_Switch_name#) timesync timep

(HP_Switch_name#) ip timep manual

(HP_Switch_name#) show timep

Timep Configuration

Time Sync Mode: Timep

TimeP Mode : DHCP Poll Interval (min): 720

NOTE: To change from one TimeP server to another, you must use the no ip timep command

to disable TimeP mode, then reconfigure TimeP in manual mode with the new server IP address.

Viewing and configuring time synchronization protocol parameters

Viewing and configuring SNTP parameters

Viewing all SNTP server addresses configured on the switch

There are two methods to view all SNTP server addresses:

• CLI

• GUI

To view the SNTP server addresses using the CLI:

Command syntax

show management

Displays all configured SNTP servers on the switch.

To view the SNTP server addresses using the GUI:

The System Information screen in the menu interface displays only one SNTP server address, even

if the switch is configured for two or three servers.

32 Time Protocols