Management and Configuration Guide K/KA/KB.15.15

If a monitored source for a remote session is configured on the switch, the following
information is displayed. Otherwise, the output displays: Mirroring is currently
disabled.
Lists the four configurable sessions on the switch.Sessions
Displays the current status of each sessionStatus
:
• active: The session is configured.
• inactive: Only the destination has been configured; the mirroring source is not
configured.
• not defined: Mirroring is not configured for this session.
Indicates whether the mirroring session is local (port), remote (IPv4), or MAC-based
(mac) for local or remote sessions.
Type
Indicates how many monitored source interfaces are configured for each mirroring
session.
Sources
Indicates whether the source is using a classifier-based mirroring policy to select inbound
IPv4 or IPv6 traffic for mirroring.
Policy
If a remote mirroring endpoint is configured on the switch, the following information
is displayed. Otherwise, the output displays: There are no Remote Mirroring
endpoints currently assigned.
Indicates whether the mirroring session is local (port), remote (IPv4), or
MAC-based (mac) for local or remote sessions.
Type
The IP address configured for the source VLAN or subnet on which the monitored
source interface exists. In the configuration of a remote session, the same UDP
source address must be configured on the source and destination switches.
UDP Source Addr
The unique UDP port number that identifies a remote session. In the configuration
of a remote session, the same UDP port number must be configured on the
source and destination switches.
UDP port
The IP address configured for the destination VLAN or subnet on which the
remote exit port exists. In the configuration of a remote session, the same UDP
destination address must be configured on the source and destination switches.
UDP Dest Addr
Identifies the exit port for a remote session on a remote destination switch.Dest Port
Figure 162 Displaying the currently configured mirroring sessions on the switch
332 Monitoring and Analyzing Switch Operation