Management and Configuration Guide K/KA/KB.15.15

Viewing the remote endpoints configured on the switch
Syntax
show monitor endpoint
Displays the remote mirroring endpoints configured on the switch. Information on
local sessions configured on the switch is not displayed. (To view the configuration
of a local session, use the
show monitor [ 1-4 | name name-str ] ]
command, as described on page 74 and page 77.)
Indicates whether the session is a port (local) or IPv4 (remote) mirroring session.Type
The IP address configured for the source VLAN or subnet on which the monitored
source interface exists. In the configuration of a remote session, the same UDP
source address must be configured on the source and destination switches.
show monitor
endpoint
The unique UDP port number that identifies a remote session. In the configuration
of a remote session, the same UDP port number must be configured on the source
and destination switches.
UDP port
The IP address configured for the destination VLAN or subnet on which the remote
exit port exists. In the configuration of a remote session, the same UDP destination
address must be configured on the source and destination switches.
UDP Dest Addr
fies the exit port for a remote session on a remote destination switch.Dest Port
Example
In Figure 163 (page 333), the show monitor endpoint output shows that the
switch is configured as the remote endpoint (destination) for two remote sessions
from the same monitored source interface.
Figure 163 Displaying the configuration of remote mirroring endpoints on the switch
Viewing the mirroring configuration for a specific session
Syntax
show monitor [ 1 - 4 | name name-str ]
Displays detailed configuration information for a specified local or remote mirroring
session on a source switch.
Displays the number of the specified session.Session
Displays the name of the session, if configured.Session Name
Indicates whether the source is using a classifier-based mirroring policy to
select inbound IPv4 or IPv6 traffic for mirroring.
Policy
Viewing the remote endpoints configured on the switch 333