KB.15.15

The new mirroring policy is automatically configured on the same port or VLAN interface on which

the mirroring ACL was assigned. The behavior of the new class and mirroring-policy configuration

exactly matches the traffic-selection criteria and mirroring destination used in the ACL-based session.)

Figure 177 (page 347) and Figure 178 (page 347) show how ACL-based selection criteria in a

mirroring session are converted to a classifier-based policy and class configuration when you install

release K.14.01 or greater on a switch.

Figure 177 Mirroring configuration in show run output in release K.13.xx

Figure 178 Mirroring configuration in show run output in release K.14.01 or greater

Using the Menu to configure local mirroring

Menu and WebAgent limits

You can use the Menu and WebAgent to quickly configure or reconfigure local mirroring on session

1 and allow one of the following two mirroring source options:

• Any combination of source ports, trunks, and a mesh.

• One static, source VLAN interface.

The Menu and WebAgent also has these limits:

• Configure and display only session 1 and only as a local mirroring session for traffic in both

directions on the specified interface. (Selecting inbound-only or outbound-only is not an option.)

• If session 1 has been configured in the CLI for local mirroring for inbound-only or outbound-only

traffic on one or more interfaces, using the Menu to change the session 1 configuration

automatically reconfigures the session to monitor both inbound and outbound traffic on the

designated interface(s.)

Using the Menu to configure local mirroring 347