Management and Configuration Guide K/KA/KB.15.15

Syntax
To disable time synchronization using the CLI:
no timesync
System Information screen of the Menu interface :
a. Set the Time Synch Method parameter to None.
b. Press [Enter], then [S] (for Save.)
Other time protocol commands
Features that apply to both SNTP and TimeP protocols.
Show management command
Syntax
show management
This command shows the switch addresses available for management, and the time
server if the switch uses one. It can help you to easily examine and compare the IP
addressing on the switch. It lists the IP addresses for all time servers configured on
the switch, plus the IP addresses and default gateway for all VLANs configured on
the switch.
Example 12 Display showing IP addressing for all configured time servers and
VLANs
HP Switch(config)# show management
Status and Counters - Management Address Information
Time Server Address : 10.10.28.100
Priority SNTP Server Address Protocol Version
-------- ----------------------------------------------
---------------
1 10.10..28.101 3
2 10.255.5.24 3
3 fe80::123%vlan10 3
Default Gateway : 10.0.9.80
VLAN Name MAC Address IP Address
------------ ------------------- -------------------
DEFAULT_VLAN 001279-88a100 10.30.248.184
VLAN10 001279-88a100 10.0.10.17
Show SNTP command
NOTE: In the factory-default configuration (where TimeP is the selected time synchronization
method), show sntp still lists the SNTP configuration, even though it is not currently in use.
Syntax
show sntp
Description: Shows configured time protocol and servers. Lists both the time
synchronization method (TimeP, SNTP, or None) and the SNTP configuration, even
if SNTP is not the selected time protocol.
Options
Authentication Displays all the configured SNTP authentication information.
Other time protocol commands 39