Management and Configuration Guide K/KA/KB.15.15

Debug Logging
Origin identifier: Outgoing Interface IP
Destination: None
Enabled debug types:
None are enabled.
Viewing Syslog/debug message sender
Use the commands show debugorshow running-config to display the identification of the
syslog message sender. The default option for origin-id is ip-address. The command show
running-configwill not display the configured option when origin-id is set to the default
value of ip address.
When hostnameor none is configured using logging origin-id, the same displays as part
of the show running-configcommand.
Example
HP_Switch(config)# show debug
Default option is ip-address. The following output of show debugwill occur
when configured without loggin origin-id.
Debug Logging
Origin identifier: Outgoing Interface IP
Destination: None
Enabled debug types:
None are enabled.
Example
HP_Switch(config)# show running-config
The command logging origin-id hostnamewill display the following.
logging origin-id hostname
Example
HP_Switch(config)# show debug
The command logging origin-id hostname will produce the following
syslog message.
Debug Logging
Origin identifier: Hostname
Destination: None
Enabled debug types: None are enabled.
Example
HP_Switch(config)# show debug
The command logging origin-id nonewill produce the following syslog
message.
Debug Logging
Origin identifier: none
Destination: None
Enabled debug types: None are enabled.
Example
HP_Switch(config)# show running-config
398 Troubleshooting