KB.15.15

Statistics Displays SNTP protocol statistics.

Configure the switch with SNTP as the time synchronization method, and then

enable SNTP in broadcast mode with the default poll interval, show sntp.

Figure 10 SNTP configuration when SNTP is not the selected time synchronization

method

Example 13 show sntp authentication command with authentication disabled

To display all the SNTP authentication keys that have been configured on the switch,

enter the show sntp authentication command.

HP Switch (config) # show sntp authentication

SNTP Authentication Information

SNTP Authentication: Enabled

Key-ID Auth Mode Trusted

------- ----------- -------

55 MD5 YES

10 MD5 NO

To display the statistical information for each SNTP server, enter the sntp

statistics command. The number of SNTP packets that have failed authentication

is displayed for each SNTP server address.

HP Switch (config) # show sntp statistics

SNTP statistics

Received Packets: 0

Sent Packets: 3

Dropped Packets: 0

SNTP Server Address Auth Failed Pkts

------------------- ----------------

10.10.10.1 0

fe80::200:24ff:fec8:4ca8 0

Show TimeP command

Using different show commands, you can display either the full TimeP configuration or a combined

listing of all TimeP, SNTP, and VLAN IP addresses configured on the switch.

Syntax

show timep

Lists both the time synchronization method (TimeP, SNTP, or None) and the TimeP

configuration, even if SNTP is not the selected time protocol. (If the TimeP Mode is

set to Disabled or DHCP, the Server field does not appear.)

40 Time Protocols