Management and Configuration Guide K/KA/KB.15.15

Debug/syslog configuration commands
Automatically sends switch-level event
messages to the switch's Event Log.
—Event notification logging
Debug and syslog do not affect this
operation, but add the capability of
directing Event Log messaging to an
external device.
Enables syslog messaging to be sent to
the specified IP address. IPv4 and IPv6
are supported.
syslog-ip-addrCommand
Optional: The logging facility
command specifies the destination
facility
(facility) subsystem used on a syslog
server for debug reports.
A text string associated with the values
of facility, severity, and system-module.
priority-desc
Enables or disables OSPFv3 (IPv6)
adjacency logging. Must be executed
neighbor-adjacency [detail]
in OSPFv3 context. The detail option
displays all the adjacency state
transitions and adjacency-related errors.
Sends Event Log messages of equal or
greater severity than the specified value
severity
to configured debug destinations. (The
default setting is to send Event Log
messages from all severity levels.)
Sends Event Log messages from the
specified system module to configured
system-module
debug destinations. The severity filter
is also applied to the system-module
messages you select.
The default setting is to send Event Log
messages from all system modules. To
restore the default setting, enter the no
logging system-module
system-module or logging
system-module all-pass
commands.
Sends ACL syslog logging to configured
debug destinations. When there is a
acldebug Command
match with a "deny" statement, directs
the resulting message to the configured
debug destinations.
Sends debug logging to configured
debug destinations for all ACL, Event
Log, IP-OSPF, and IP-RIP options.
all
Displays CDP information.cdp
logging: Disables or re-enables syslog
logging on one or more syslog servers
destination
configured with the logging
syslog-ip-addr command.
session: Assigns or re-assigns
destination status to the terminal device
that was most recently used to request
debug output.
Debug/syslog operation 401