Management and Configuration Guide K/KA/KB.15.15
Figure 208 Debug/syslog configuration for multiple debug types and multiple
destinations
Debug command
At the manager level, use the debug command to perform two main functions:
• Specify the types of event messages to be sent to an external destination.
• Specify the destinations to which selected message types are sent.
By default, no debug destination is enabled and only Event Log messages are enabled to be sent.
NOTE: To configure a syslog server, use the logging syslog-ip-addr command.
Configuring the types of debug messages that the switch can send to configured debug destinations
Syntax
[ no ] debug debug-type
When a match occurs on an ACL "deny" ACE
(with log configured), the switch sends an ACL
message to configured debug destinations.
acl
Debug/syslog operation 407