Management and Configuration Guide K/KA/KB.15.15

NOTE: Beginning with software release
K.14.01, ACE matches (hits) for permit and deny
entries can be tracked using the
show statistics [ aclv4 | aclv6 ]
command.
(Default: Disabled—ACL messages for traffic that
matches "deny" entries are not sent.)
Configures the switch to send all debug message
types to configured debug destinations.
all
(Default: Disabled—No debug messages are
sent.)
Sends CDP information to configured debug
destinations.
cdp
logging—Disables or re-enables syslog logging
on one or more syslog servers configured with
the logging syslog-ip-addr command.
destination
session—Assigns or re-assigns destination status
to the terminal device that was most recently used
to request debug output.
buffer—Enables syslog logging to send the
debug message types specified by the debug
debug-type command to a buffer in switch
memory.
Configures the switch to send Event Log messages
to configured debug destinations.
event
NOTE: This value does not affect the reception
of event notification messages in the Event Log
on the switch.
Event Log messages are automatically enabled
to be sent to debug destinations in these
conditions:
• If no syslog server address is configured and
you enter the logging syslog-ip-addr
command to configure a destination address.
• If at least one syslog server address is
configured in the startup configuration, and
the switch is rebooted or reset.
Event log messages are the default type of debug
message sent to configured debug destinations.
ip [ fib | forwarding | ospf | ospfv3 | packet | pim | rip ]
Sends IP messages to configured destinations.
For the configured debug destinations:
events—Sends IP forwarding information base
events.
ip [fib [events]]
ip [ospf [ adj | event | flood | lsa-generation | packet packet-type |
retransmission | spf ]]
For the configured debug destinations:
ospf—Enables the specified IP-OSPF message
type.
adj—Adjacency changes.
event—OSPF events.
flood—Information on flood
messages.
408 Troubleshooting