KB.15.15

NOTE: Debug messages from the switches covered in this guide have a debug

severity level. Because the default configuration of some syslog servers ignores

syslog messages with the debug severity level, ensure that the syslog servers you

want to use to receive debug messages are configured to accept the debug level.

Enables transmission of event notification

messages to the CLI session that most recently

session

executed this command. The session can be on

any one terminal emulation device with serial,

Telnet, or SSH access to the CLI at the Manager

level prompt.

If more than one terminal device has a console

session with the CLI, you can redirect the

destination from the current device to another

device. Do so by executing debug

destination session in the CLI on the

terminal device on which you now want to display

event messages. Event message types received

on the selected CLI session are configured with

the debug debug-type command.

Enables syslog logging to send the debug

message types specified by the debug

buffer

debug-type command to a buffer in switch

memory.

To view the debug messages stored in the switch

buffer, enter the show debug buffer

command.

Logging command

At the global configuration level, the loggingcommand allows you to enable debug logging on

specified syslog servers and select a subset of Event Log messages to send for debugging purposes

according to:

• Severity level

• System module

414 Troubleshooting