Management and Configuration Guide K/KA/KB.15.15

The source IP address must be owned by the
router.
If a VLAN is specified, the IP address associated
with the specified VLAN is used.
Size of packet sent.data-size 0-65471
Default: 0 (zero)
The data pattern in the packet.data-fill 0-1024
Default: Zero length string
Specify an IP option, such as loose or strict source
routing, or an include-timestamp option:
ip-option
include-timestamp: Adds the timestamp
option to the IP header. The timestamp displays
the amount of travel time to and from a host.
Default: 9
include-timestamp-and-address: Records
the intermediate router's timestamp and IP
address.
Default: 4
include-timestamp-from: Records the
timestamp of the specified router addresses.
loose-source-route IP-addr: The
loose-source-route option prompts for the
IP address of each source IP on the path. It allows
you to specify the IP addresses that you want the
ping packet to go through; the packet may go
through other IP addresses as well.
record-route 1-9: Displays the IP addresses
of the interfaces that the ping packet goes through
on its way to the destination and on the way
back.
When specified without loose or strict recording,
the source route is not recorded. The source route
is automatically recorded when loose or strict
source routing is enabled.
Default: 9
strict-source-route IP-addr: Restricts
the ping packet to only those IP addresses that
have been specified and no other addresses.
Specifies the type of service to be entered in the
header packet.
tos 0-255
Default: 0 (zero)
428 Troubleshooting