Management and Configuration Guide K/KA/KB.15.15
Displays the running configuration.
Displays the startup configuration.show config
Displays the running-config file.show running-config
Viewing the configuration file (WebAgent)
To display the running configuration using the WebAgent:
1. In the navigation pane, click Troubleshooting.
2. Click Configuration Report.
3. Use the right-side scroll bar to scroll through the configuration listing.
Viewing a summary of switch operational data
Syntax
show tech
By default, the show tech command displays a single output of switch operating
and running-configuration data from several internal switch sources, including:
• Image stamp (software version data)
• Running configuration
• Event Log listing
• Boot history
• Port settings
• Status and counters—port status
• IP routes
• Status and counters—VLAN information
• GVRP support
• Load balancing (trunk and LACP)
Example
Figure 229 (page 434) shows sample output from the show tech command.
Viewing Switch Configuration and Operation 433