Management and Configuration Guide K/KA/KB.15.15

To limit the amount of crash data displayed,
specify an installed module or management
modules, where:
• slot-id: Includes the crash data from an
installed module. Valid slot IDs are the letters
a through h.
• master: Includes the crash data from both
management modules.
Includes the crash logs from all management and
interface modules in show tech command
output.
crash-log [ slot-id | master ]
:
To limit the amount of crash-log data displayed,
specify an installed module or management
modules, where:
slot-id: Includes the crash log from an installed
module. Valid slot IDs are the letters a through h.
master: Includes the crash log from both
management modules.
Copies the contents of the Event Log to show
tech command output.
event-log
Includes the contents of the running configuration
file in show tech command output
running-config
Includes the contents of the startup configuration
file in show tech command output.
startup-config
Downloads the contents of a configuration file
from a remote host to show tech command
output, where:
tftp config startup-config |
running-config
ip-addr remote-file [ pc | unix
]
ip-addr: Specifies the IP address of the remote
host device.
remote-file: Specifies the pathname on the
remote host for the configuration file whose
contents you want to include in the command
output.
pcunix: Specifies whether the remote host is a
DOS-based PC or UNIX workstation.
Copies the contents of a configuration file or ACL
command file from a USB flash drive to show
tech command output, where:
usb config startup-config
filename | command-file
acl-filename.txt
startup-config filename : Specifies the
name of a startup configuration file on the USB
drive.
command-file acl-filename.txt :
Specifies the name of an ACL command file on
the USB drive.
Copies the contents of a configuration file or ACL
command file from a serially connected PC or
xmodem config startup-config |
config filename | command-file
acl-filename.txt [ pc | unix ]
UNIX workstation to show tech command
output, where:
startup-config: Specifies the name of the
startup configuration file on the connected device.
config filename : Specifies the pathname
of a configuration file on the connected device.
command-file acl-filename.txt :
Specifies the pathname of an ACL command file
on the connected device.
436 Troubleshooting