Management and Configuration Guide K/KA/KB.15.15

If the specified management module is not there or is in failed mode, this message displays:
The specified module is not present or is in failed state.
Example
Figure 251 (page 469) shows an example of setting management module 2 to be the active
management module.
Figure 251 Setting a management module to be active on the next boot
If management module redundancy has been disabled and you specify the standby module with
the active-management command, upon rebooting, the offline module becomes the standby
module. The state of redundancy (enabled or disabled) is based on the value in the configuration
file in the offline (now standby) module. The configuration files have not been synchronized if
management module redundancy has been disabled. An example of making the offline management
module become the standby management module when redundancy is disabled is shown in
Figure 252 (page 470).
Setting the active management module for next boot 469