Management and Configuration Guide K/KA/KB.15.15

Figure 252 Showing the results of switching to standby module when redundancy is disabled
Hotswapping out the active management module
1. On the management module to be hotswapped out, press the MM Shutdown button. It is
located between the Module Operation and Component Status LEDs. (See Figure 253
(page 470).)
Figure 253 The MM Shutdown button
2. The Dwn LED to the right of the MM Shutdown button begins flashing green. File synchronization
will complete before shutdown occurs.
3. The standby module takes control and the switchover occurs. It is now the active management
module.
470 Chassis Redundancy (8200zl Switches)