KB.15.15

Example

Figure 256 show redundancy detail command

Viewing which software version is in each flash image

The show flash command displays which software version is in each flash image. The Default

Boot field displays which flash image will be used for the next boot.

Example

Figure 257 show flash command

Viewing system software image information for both management modules

The show version command displays system software image information for both management

modules, as well as which module is the active management module and which is the standby

management module. The Boot Image field displays which flash image last booted from, even if

the boot set-default command has been set to change the flash booted from on the next

boot. The output of the show version command when redundancy is enabled is shown in

Figure 258 (page 473).

Example

Figure 258 show version command when redundancy is enabled

Viewing management information 473