KB.15.15

When redundancy is disabled, the output of the show version command changes, as shown

in Figure 259 (page 474).

Example

Figure 259 show version command when redundancy is disabled

Viewing the status of the switch and its management modules

The show logging command displays the status of the switch and its management modules. See

“Displaying module events” (page 477). To show log messages in reverse chronological order (most

recent messages displayed first), enter show log -r.

Example

Figure 260 show log command output

Standby management module commands

The standby management module, by design, has very little console capability. You can use three

commands—show flash, show version, and show redundancy. The show redundancy

command displays when a management module is in standby mode.

Viewing redundancy status on the standby module

Use the show redundancy command to display redundancy status on the standby module, as

shown in Figure 261 (page 475). This command displays the flash image last booted from, even if

the boot set-default command has been set to change the flash booted from on the next

boot.

474 Chassis Redundancy (8200zl Switches)