KB.15.15

Example

Figure 261 show redundancy command for standby module

Viewing the flash information on the standby module

Use the show flash command to display the flash information on the standby module, as shown

in Figure 262 (page 475). The Default Boot field displays which flash image will be used for the

next boot.

Example

Figure 262 show flash command for standby module

Viewing the version information on the standby module

Use the show version command to display the version information on the standby module, as

shown in Figure 263 (page 475). The Boot Image field displays which flash image was last booted

from, even if the boot set-default command has been set to change the flash booted from

on the next boot. Unlike executing the show version command on an active management

module, this command shows only the running version of software on the standby management

module.

Example

Figure 263 show version command for standby module

Setting the default flash for boot

You can set which flash image to boot from as the default image on boot by using this command:

Setting the default flash for boot 475