Management and Configuration Guide K/KA/KB.15.15

ActionCommand
If the management module performs a switchover, the LED does not remain
lit.
chassislocate
The clear crypto command causes public keys to be deleted from both
modules when the second module is in standby mode.
clear
Console settings, such as mode, flow-control, and baud-rate, are the same
on both management modules. There cannot be individual settings for
each management module.
console
Files are automatically sync'd from the active management module to the
standby management module.
copy
When no parameter is specified with the copy crash-data or copy
crash-log command, files from all modules (management and interface)
are concatenated.
NOTE: If redundancy is disabled or the standby module failed selftest,
the copy command affects only the active management module.
The copy core-dump standby flash command copies the standby
management module's coredump to the active management module's
copy core-dump [ mm | standby
| flash | xmodem | usb
filename ]
flash. The destination file is fixed as dumpM1.cor or dumpM2.cor,
depending on which module is the standby management module.
The
copy core-dump [ mm | standby | flash | xmodem |
usb <filename> ]
command copies the core file of the active management module or the
standby management module to a USB flash drive or to an xmodem host.
Enables or disables a core dump on a management module.core-dump management-module
Authentication files for ssh or the https server are copied to the standby
management module. The clear crypto command deletes the public
keys from both modules when the second module is in standby mode.
crypto
Erases the software version on the active and standby modules. If
redundancy has been disabled, or if the standby module has not passed
selftest, the flash is not erased on the standby module.
erase flash
Erases the config file on the active and standby modules. If redundancy
has been disabled, or if the standby module has not passed selftest, the
config file is not erased on the standby module.
erase config
Affects both modules if the second module is in standby mode. If
redundancy has been disabled, or if the standby module has not passed
selftest, the startup-config file is not erased on the standby module.
erase startup-config
When fastboot is enabled, this information is saved to the standby
management module when the config files are sync'd. The fastboot value
is used during the next boot on both modules.
fastboot
This command and its options affect only the active management module.front-panel-security
factory-reset
password-clear
password-recovery
Does not affect the console on the standby module.kill
Log messages from a formerly active management module are available
on the current active management module after a switchover.
log
Affects only the active management module until a switchover occurs, at
which time it affects the new active module.
password (set or clear)
CLI commands affected by redundant management 495