Management and Configuration Guide K/KA/KB.15.15

C Network Out-of-Band Management (OOBM) for the 6600
Switch
OOBM Configuration
OOBM configuration commands can be issued from the global configuration context (config) or
from a specific OOBM configuration context (oobm.)
Entering the OOBM configuration context from the general configuration context
Syntax
oobm
Enters the OOBM context from the general configuration context.
Example
HP Switch (config)# oobm
HP Switch (oobm)#
Enabling and disabling OOBM
From the OOBM context:
Syntax
enable
disable
From the general configuration context:
Syntax
oobm enable
oobm disable
Enables or disables networked OOBM on the switch.
OOBM is not compatible with either a management VLAN or stacking. If you attempt
to enable OOBM when a management VLAN is enabled or when stacking is
enabled, the command will be rejected and you will receive an error message.
If an OOBM IP address exists and you disable OOBM, the OOBM IP address
configuration is maintained. If you enable OOBM and there is a pre-existing OOBM
IP address, it will be reinstated.
Network OOBM is enabled by default.
Examples
HP Switch (oobm)# enable
HP Switch (oobm)# disable
HP Switch (config)# oobm enable
HP Switch (config)# oobm disable
Enabling and disabling the OOBM port
The OOBM interface command enables or disables the OOBM interface (that is, the OOBM
port, as opposed to the OOBM function.)
From the OOBM context:
OOBM Configuration 505