Management and Configuration Guide K/KA/KB.15.15

Syntax
interface [ enable | disable ]
From the general configuration context:
Syntax
oobm interface [ enable | disable ]
Enables or disables the networked OOBM interface (port.)
Examples
HP Switch (oobm)# interface enable
HP Switch (config)# oobm interface disable
Setting the OOBM port speed
The OOBM port operates at 10 Mbps or 100 Mbps, half or full duplex. These can be set explicitly
or they can be automatically negotiated using the auto setting.
From the OOBM context:
Syntax
interface speed-duplex [ 10-half | 10-full | 100-half |
100-full | auto ]
From the general configuration context:
Syntax
oobm interface speed-duplex [ 10-half | 10-full | 100-half |
100-full | auto ]
Enables or disables the networked OOBM interface (port.) Available settings are:
10 Mbps, half-duplex10-half
10-Mbps, full-duplex10-full
100-Mbps, half-duplex100-half
100-Mbps, full-duplex100-full
auto negotiate for speed and duplexauto
Example
HP Switch (oobm)# interface speed-duplex auto
Configuring an OOBM IPv4 address
Configuring an IPv4 address for the OOBM interface is similar to VLAN IP address configuration,
but it is accomplished within the OOBM context.
From the OOBM context:
Syntax
[ no ] ip address [ dhcp-bootp | ip-address/mask-length ]
From the general configuration context:
506 Network Out-of-Band Management (OOBM) for the 6600 Switch