Management and Configuration Guide K/KA/KB.15.15

OOBM Interface Status : Up
OOBM Port : Enabled
OOBM Port Speed : Auto
Showing OOBM IP configuration
Syntax
show oobm ip
Summarizes the IP configuration of the OOBM interface. This command displays
the status of IPv4 (enabled/disabled), the IPv4 default gateway, and the IPv4 address
configured for the interface.
You can issue this command from any context.
Example
HP Switch# show oobm ip
Showing OOBM ARP information
Syntax
show oobm arp
Summarizes the ARP table entries for the OOBM interface.
You can issue this command from any context.
Example
HP Switch# show oobm arp
Application server commands
Application servers (as described in OOBM and server applications in “Concepts” (page 511))
have added a listen keyword with oobm|data|both options to specify which interfaces are
active.
Default value is both for all servers.
Syntax
telnet-server [listen oobm | data | both ]
Syntax
ip ssh [listen oobm | data | both ]
Syntax
snmp-server [listen oobm | data | both ]
Syntax
tftp server [listen oobm | data | both ]
Syntax
web-management [listen oobm | data | both ]
In all cases, show running-config displays the server configurations.
Use the no form of the command to prevent the server from running on either interface.
508 Network Out-of-Band Management (OOBM) for the 6600 Switch