Management and Configuration Guide K/KA/KB.15.15

Example 23 SNTP configuration information
(HP_Switch_name#) show sntp
SNTP Configuration
SNTP Authentication : Enabled
Time Sync Mode: Sntp
SNTP Mode : Unicast
Poll Interval (sec) [720] : 720
Priority SNTP Server Address Protocol Version KeyId
-------- --------------------------------------- ---------------- -----
1 10.10.10.2 3 55
2 fe80::200:24ff:fec8:4ca8 3 55
Example 24 show sntp authentication command output
To display all the SNTP authentication keys that have been configured on the switch, enter the
show sntp authentication command.
HP Switch (config) # show sntp authentication
SNTP Authentication Information
SNTP Authentication: Enabled
Key-ID Auth Mode Trusted
------- ----------- -------
55 MD5 YES
10 MD5 NO
To display the statistical information for each SNTP server, enter the sntp statistics command.
The number of SNTP packets that have failed authentication is displayed for each SNTP server
address.
HP Switch (config) # show sntp statistics
SNTP statistics
Received Packets: 0
Sent Packets: 3
Dropped Packets: 0
SNTP Server Address Auth Failed Pkts
------------------- ----------------
10.10.10.1 0
fe80::200:24ff:fec8:4ca8 0
Viewing statistical information for each SNTP server
To display the statistical information for each SNTP server, enter the show sntp statistics
command.
Syntax
show sntp statistics
Shows the number of SNTP packets that have failed authentication for each SNTP
server address.
Configuring the key-identifier, authentication mode, and key-value 53