Management and Configuration Guide K/KA/KB.15.15

Example 25 SNTP authentication statistical information
(HP_Switch_name#) show sntp statistics
SNTP Statistics
Received Packets : 0
Sent Packets : 3
Dropped Packets : 0
SNTP Server Address Auth Failed Pkts
--------------------------------------- ----------------
10.10.10.1 0
fe80::200:24ff:fec8:4ca8 0
Example 26 show sntp statistics command
Displays all SNTP authentication keys configured on the switch.
HP Switch (config) # show sntp authentication
SNTP Authentication Information
SNTP Authentication: Enabled
Key-ID Auth Mode Trusted
------- ----------- -------
55 MD5 YES
10 MD5 NO
Shows the statistical information for each SNTP server. The number of SNTP packets that have
failed authentication is displayed for each SNTP server address.
HP Switch (config) # show sntp statistics
SNTP statistics
Received Packets: 0
Sent Packets: 3
Dropped Packets: 0
SNTP Server Address Auth Failed Pkts
------------------- ----------------
10.10.10.1 0
fe80::200:24ff:fec8:4ca8 0
Configuring a key-id as trusted
Syntax
sntp authentication key-id key-id trusted
Syntax
no sntp authentication key-id key-id trusted
Trusted keys are used during the authentication process. You can configure the switch with up to
eight sets of key-id/key-value pairs. One specific set must selected for authentication; this is done
by configuring the set as trusted. The key-id itself must already be configured on the switch.
To enable authentication, at least one key-id must be configured as trusted.
The no version of the command indicates the key is unreliable (not trusted.)
Default: No key is trusted by default.
54 Time Protocols