Management and Configuration Guide K/KA/KB.15.15

the original server, the switch accepts a broadcast time update from the next server
it detects.
Viewing SNTP authentication configuration information
The show sntp command displays SNTP configuration information, including any SNTP
authentication keys that have been configured on the switch.
Example 28 SNTP configuration information
HP Switch(config)# show sntp
SNTP Configuration
SNTP Authentication : Enabled
Time Sync Mode: Sntp
SNTP Mode : Unicast
Poll Interval (sec) [720] : 720
Priority SNTP Server Address Protocol Version KeyId
-------- --------------------------------------- ---------------- -----
1 10.10.10.2 3 55
2 fe80::200:24ff:fec8:4ca8 3 55
Example 29 show sntp authentication
To display all the SNTP authentication keys that have been configured on the switch, enter the
show sntp authentication command.
HP Switch (config) # show sntp authentication
SNTP Authentication Information
SNTP Authentication: Enabled
Key-ID Auth Mode Trusted
------- ----------- -------
55 MD5 YES
10 MD5 NO
Example 30 SNTP Statistics command output
To display the statistical information for each SNTP server, enter the sntp statistics command.
The number of SNTP packets that have failed autherntication is displayed for each SNTP server
address.
HP Switch (config) # show sntp statistics
SNTP statistics
Received Packets: 0
Sent Packets: 3
Dropped Packets: 0
SNTP Server Address Auth Failed Pkts
------------------- ----------------
10.10.10.1 0
fe80::200:24ff:fec8:4ca8 0
Viewing all SNTP authentication keys that have been configured on the
switch
Enter the show sntp authenticationn command.
56 Time Protocols