KB.15.15

Viewing the current TimeP configuration

Using different show commands, you can display either the full TimeP configuration or a combined

listing of all TimeP, SNTP, and VLAN IP addresses configured on the switch.

Syntax

show timep

Lists both the time synchronization method (TimeP, SNTP, or None) and the TimeP

configuration, even if SNTP is not the selected time protocol. (If the TimeP Mode is

set to Disabled or DHCP, the Server field does not appear.)

Example 32 TimeP configuration when TimeP is the selected Time synchronization

method

If you configure the switch with TimeP as the time synchronization method, then

enable TimeP in DHCP mode with the default poll interval, show timep lists the

following:

HP Switch(config)# show timep

Timep Configuration

Time Sync Mode: Timep

TimeP Mode [Disabled] : DHCP Server Address : 10.10.28.103

Poll Interval (min) [720] : 720

Example 33 TimeP configuration when TimeP is not the selected time synchronization

method

If SNTP is the selected time synchronization method, show timep still lists the

TimeP configuration even though it is not currently in use. Even though, in this

example, SNTP is the current time synchronization method, the switch maintains

the TimeP configuration.

HP Switch(config)# show timep

Timep Configuration

Time Sync Mode: Sntp

TimeP Mode [Disabled] : Manual Server Address : 10.10.28.100

Poll Interval (min) [720] : 720

Syntax

show management

Helps you to easily examine and compare the IP addressing on the switch. It lists

the IP addresses for all time servers configured on the switch plus the IP addresses

and default gateway for all VLANs configured on the switch.

Viewing the current TimeP configuration 59