Management and Configuration Guide K/KA/KB.15.15

For switches that have a separate out-of-band management port, oobm specifies
that SNTP traffic goes through that port. (By default, SNTP traffic goes through the
data ports.)
Disabling TimeP in manual mode
Syntax
no ip timep
Disables TimeP.
Enabling TimeP in DHCP Mode
Because the switch provides a TimeP polling interval (default:720 minutes), you need only these
two commands for a minimal TimeP DHCP configuration:
Syntax
timesync timep
Selects TimeP as the time synchronization method.
Syntax
ip timep dhcp
Configures DHCP as the TimeP mode.
Example 36 TimeP synchronization method
Follow this example to enable TimeP for DHCP mode if Time Synchronization is configured for
SNTP.
1. View the current time synchronization.
2. Select TimeP as the synchronization mode.
3. Enable TimeP for DHCP mode.
4. View the TimeP configuration.
Figure 21 Enabling TimeP operation in DHCP mode
Enabling TimeP in Manual Mode
Syntax
timesync timep
Selects TimeP.
Syntax
ip timep manual <ip-addr>
62 Time Protocols