KB.15.15

Example 41 Retrieved configuration file when include credentials is not configured

HP Switch (config) # copy tftp startup-config 10.2.3.44 config1

Switch reboots ...

Startup configuration

timesync sntp

sntp broadcast

sntp 50 sntp server priority 1 10.10.10.2.3

sntp server priority 2 fe80::200:24ff:fec8:4ca8 4

NOTE: The SNTP authentication line and the Key-ids are not displayed. You must reconfigure

SNTP authentication.

If include-credentials is configured, the SNTP authentication configuration is saved in the

configuration file. When the show config command is entered, all of the information that has

been configured for SNTP authentication displays, including the key-values.

Figure 23 Saved SNTP Authentication information when include-credentials is configured

SNTP messages in the event log

If an SNTP time change of more than three seconds occurs, the switch's Event Log records the

change. SNTP time changes of less than three seconds do not appear in the Event Log.

Viewing current resource usage

Syntax

show qos | access-list | policy

resources

Displays the resource usage of the policy enforcement engine on the switch by

software feature. For each type of resource, the amount still available and the

amount used by each software feature is shown.

This output allows you to view current resource

usage and, if necessary, prioritize and

show resources

SNTP messages in the event log 69