Management and Configuration Guide K/KA/KB.15.15

Example 47 Show services device
HP-8212zl# show services d device
Services Module Device Configuration
Device | State
----------------|--------------------
USB | disabled
Shutdown | enabled
PXE | enabled
Requesting a reboot
This command requests a reboot (graceful shutdown and restart) of the x86.
Syntax
services <slot>boot[product|PXE|service|USB]
product Boot to the Product OS.
PXE Boot to the PXE or Product OS (if supported).
service Boot to the Service OS.
USB Boot to the USB or Product OS (if supported).
NOTE: If no parameters are given, the switch attempts to boot to the same OS
(product, service, or USB) that was enabled before the command was given. If the
services <slot> boot product|usb command is given on a non-permitted
module, one of the following error messages is returned:
HP-8212zl# services b boot product
Command not supported for the Services module in slot B.
HP-8212zl# services b boot pxe
Command not supported for the Services module in slot B.
HP-8212zl# services b boot usb
Command not supported for the Services module in slot B.
Services in Operator/Manager/Configure context
This top-level command requires a slot-name parameter followed a subcommand. Permitted
subcommands depend on one of the three context: operator, manager, or configure.
Services in operator context
Displays applications installed and running for the services module in the Operator context.
Syntax
services <slot-id>[<index> | locator | name <name>]
Slot-id Device slot identifier for the services module.
Integer Index of the services CLI to access.
Locator Control services module locator LED.
Name Name of the services CLI to access.
<Slot-id> <index> Configure parameters for the installed
application.
<Slot-id> locator Controls services module locator LED.
Viewing port status and configuration 79