KB.15.15

<slot-id> reload Reset the services module.

<slot-id> serial Connect to services module via

serial port.

<slot-id> shutdown Shutdown (halt) the services

module.

Boot Reboot the services module.

Integer Index of the services CLI to access.

Locator Control services module locator LED.

Name Name of the services CLI to access.

Reload Reset the services module.

Serial Connect to application via serial port.

Shutdown Shutdown (halt) the services module.

Enable or disable devices.

Enable or disable devices. This command must be run from the configure context.

Syntax

[no]services <slot> device [PXE|shutdown|USB|CF]

PXE Enable or disable booting from PXE (if supported).

shutdown Enable or disable the shutdown or reset button.

USB Enable or Disable the USB after boot.

CF Enable or disable the Compact Flash or SD1 card.

Accessing CLI-passthrough

Accessing the CLI-passthrough feature on modules that support the feature. Feature can be reported

by the show servicescommand given with no additional parameters.

Syntax

services <slot>[<index>|<name>

ASCII-STR Enter an ASCII string.

Example 48 Show services

HP-8212zl# show services

Installed Services

Slot Index Description Name

H,L 1. Services zl Module

services-module

L 2. HP ProCurve MSM765 zl Int-Ctlr

msm765-applicati

H 3. Threat Management Services zl Module tms-module

Show services set locator module

This command sets the Module Locator LED to either solid-on, off or slow-blink for a specified

duration of time or to turn it off before the previously-specified time has passed. Options are

permitted in this command for the Operator.

Viewing port status and configuration 81