Management and Configuration Guide K/KA/KB.15.15

Figure 32 Listing of the startup-config file with a friendly port name configured
Configuring the type of a module
Syntax
module module-num type module-type
Allows you to configure the type of the module.
Clearing the module configuration
Syntax
[no] module slot
Allows removal of the module configuration in the configuration file after the module has been
removed. Enter an integer between 1 and 12 for slot.
Example
(HP_Switch_name#) no module 3
Configuring uni-directional link detection
Syntax
[ no ]interface <port-list> link-keepalive
Enables UDLD on a port or range of ports.
To disable this feature, enter the no form of the command.
Default: UDLD disabled
Syntax
link-keepalive interval interval
Determines the time interval to send UDLD control packets. The interval parameter specifies
how often the ports send a UDLD packet. You can specify from 10 to 100, in 100-ms increments,
where 10 is 1 second, 11 is 1.1 seconds, and so on.
Default: 50 (5 seconds)
Configuring the type of a module 97